JET SET
EXPANSION KIT FOR SHOWERS AND ALIKE

Indications:
With a truly tempting price, and without having to break the wall, you can install a "custom-made" vertical hydromassage system quickly and by yourself (without expert help).

The kit is called Jetset, it’s made by Vitalsan, and besides being easy and quick to install, it has a hydromassage jet system that’s attached with suction cups, so it can be moved whenever you like.The principle is as simple as can be, and uses the existing shower plumbing. A flow deviator is installed between the water outlet and the connector for the flexible line to the shower head.This deviator delivers water under pressure from outlets mounted on the wall, which are connected with small flexible plastic tubes that are cut to the desired size. 

With this system, the outlets can be positioned at different points on the wall depending on the lenght the tubes are cut to.Thus, both tall and short people (for examples adults and children) can place the whirlpool jet at the desired height.
But that’s not all. The hydromassage outlets can also be pointed to apply massage action to the desired points (neck, back, buttocks and so on) more precisely.

Directions for use:
Please cut tube (F) (total length ca. 2,5 meters) in your personal desired lengths.
You need 5 pieces.
1x for water / shower tap to "Jet-set" tap (A).
4x for the massage "JETS" (B) to "Jet-set" tap (A)

Please take notice of the narrows for the water direction, on the back of the "Jet-set" tap (A).
These narrows correspond to the "IN" and "OUT" words written on the front of the tap.
"IN" is by the entrance hole for incoming water / shower tap.
"OUT" is by the exit hole for water flowing toward the shower hose.

Please follow these instructions carefully:
1) Slip the small plastic ring (E) onto one of the tubes ends (F).
2) Push nipple(C) into the tube (F).
3) Push the small plastic ring (E) back onto the nipple (C) in order to fix and block the nipple to the tube.
4) Then mount "Jet Set" tap (A) with rubber ring (D) in between as shown in picture.

On the back of the "Jet-Set" tap (A), there’s a screw.
It is possible to adapt the movement of the tap for a fine tuning by turning the screw SLIGHTLY to the left or to the right, respectively for an easier or a harder movement.

3 different positions of the "Jet-set" tap (A):
1)Turn tap to the LEFT: you will have water from the shower only.
2)Turn tap to the RIGHT: you will have water from the massage-"Jets" (B) only.
3)Turn tap to a MIDDLE position: you will have water both from shower and massage-"Jets" at the same time.